Genie S-60 Service Manual page 97

Third Edition • First Printing
2 Place a suitable container under the engine
pivot plate.
3 At the fuel pump, disconnect the fuel hose to
the fuel tank and drain the fuel tank into the
container.
4 Remove and replace all of the fuel hoses and
clamps according to the following illustration:
Explosion and fire hazard. Fuel
Injection systems operate at a
very high pressure. Fuel may be
expelled under pressure if the
hoses are removed too quickly.
Loosen the fuel lines very slowly
to allow the fuel pressure to
dissipate gradually. Wrap a cloth
around fuel hoses to absorb
leaking fuel before disconnecting
them.
Part No. 65196
Section 4 • Scheduled Maintenance Procedures
Genie S-60 & Genie S-65
TABLE D PROCEDURES
a
b b b b
e
d
f
a hose from the injector to
the fuel tank
b hoses connecting injectors
c hose from the fuel shutoff valve
to the fuel pump
d hose from the fuel pump to
the fuel filter
e hose from the fuel filter to the
injection pump
f hose from the injection pump
to the injectors
b b b
c
4 - 71