Engine Cranks Over But Will Not Start - Gasoline/Lpg Models - Genie S-60 Service Manual

Section 5 • Troubleshooting Flow Charts
Chart 2
Engine Cranks
Over But Will
Not Start -
Gasoline/LPG
Models
Be sure to check the
engine oil level and fill
as needed.
Be sure to check fuel
levels and engine
coolant level.
Be sure the gasoline
shut-off valve is in the
or position.
ON OPEN
Perform following tests
in gasoline mode only.
Be sure that the water
temperature gauge
does not show an
overheated condition.
5 - 10
See Repair Section,
How to Retrieve Fault
yes
Codes. Is there a fault
code stored in the ECM
memory?
no
less
With the key switch
than
turned to ground
11V
controls and both
Emergency Stop buttons
pulled out to the
ON
position, move the start
toggle switch to either
side and check battery
voltage while engine is
cranking.
more than 11V
With the key switch
no
turned to the
OFF
position and both
Emergency Stop buttons
pulled out to the
ON
position, turn the key
switch to ground
controls and listen for
the fuel pump to turn
ON
for approximately 2
seconds and then shut
. Did the fuel pump
OFF
turn on?
yes
good
Remove #1 spark plug
spark
and ground spark plug
body. Crank engine and
observe spark.
weak or no spark
Continued on the next
page.
Genie S-60 & Genie S-65
Third Edition • First Printing
Check for poor terminal
connections OR check
for shorted or damaged
wires that go from the
ECM to the sensor that
is causing the fault OR
replace the sensor OR
consult Genie Industries
Service Department.
Check battery condition
OR check alternator OR
check for short circuits
OR check battery cables
OR replace the battery.
Test the fuel pump
relay. See Repair
Section OR replace the
fuel pump.
Consult Genie Industries
Service Department.
Refer to the fault code
chart in this section for
a description of the fault
and recommended
repairs.
Part No. 65196