Operations After Printing; Cutting Media - Oce CS9090 User Manual

5.7 OPERATIONS AFTER PRINTING

The operations performed after printing, are described here.

5.7.1 Cutting media

The media cutting procedure is described below.
Roll media is automatically cut after printing when "Auto" is set on the cut media menu and roll media has
been set.
When the operation panel is in the normal status, and the product is in the following conditions, the media
can be cut on the desired position:
•
When roll media has been set:
•
If "OFF" is set on the cut media menu
•
If "Take Up Roll" has been set in the media detection setup menu
•
When sheet media has been set
Follow the steps below to cut the media.
Make sure that the MEDIA SET lamp on the operation panel is off.
Step 1 :
Press the [F3] key on the operation panel.
Step 2 :
Shift to the cut and feed menu.
I)
Feed media to the desired position according to the procedure in "Feeding media".
Step 3 :
Press the [F1] key on the operation panel.
Step 4 :
The media is cut at its position when the [ENTER] key has been pressed.
I)
Notes
If the front edge of the roll media is not straight when you load new roll media, you should cut its edge.
Cutting blades are consumable. Replace them at regular intervals following "Replacing the cutting blade".
AP-75036 - Revision 1.3 – 20/03/06 135
Chapter 5: Handling the printer
User's Guide CS9000 series