Command Select Menu; Print Step Menu; Print Position Menu - Oce CS9090 User Manual

5.4.2.11 Command select menu

To make the settings for the conditions of printer commands sent from the computer to the printer.
Setup items Parameters
Command MH-GL, GL2
MH-GL2
<RTL-PASS>
-

5.4.2.12 Print step menu

Set the units for amount of movement for printing.
Setup items Parameters
Print step <0.010mm>
<0.025mm>
-
Notes
Please note that some software packages use the "step per mm" terminology, in which case a program step
of 0.025 mm corresponds with 40 steps per mm and a program step of 0.010 mm with 100 steps per mm.

5.4.2.13 Print position menu

Set the initial writing position for printing.
Setup items Parameters
Print position <P1>
LL
Full
-
AP-75036 - Revision 1.3 – 20/03/06
Description
To set to MH-GL, GL2.
To set to MH- GL2.
To set to RTL-PASS.
To shift to the previous hierarchy menu.
Description
To set the printing units to 0.010mm.
To set the printing units to 0.025mm.
To shift to the previous hierarchy menu.
Description
To set the initial location of the scaling point.
To set the lower left position of the hard clip.
To set the lower left position of the media.
To shift to the previous hierarchy menu.
99
Chapter 5: Handling the printer
User's Guide CS9000 series