Figure 5-8. Slide Assembly Inner Member Mounting
12.
Lift the T1000 AS chassis with the attached inner slide members and carefully
insert the inner slide member rollers into the middle slide members that were
previously mounted on the frame.
13.
Simultaneously press the release buttons on the inner slide members once
when the buttons encounter the middle slide members.
NOTE: The inner slide members will travel approximately two more
inches and the release buttons will detent into the round cutouts of the
middle slide members. This is the standard open position of the slides.
910-0095-001 Revision J November 2007
Release
Button
Four #10-32
Phillips Screws
Inner Slide Member
How to Install an Individual T1000 AS Unit
Chassis
Roller Bearings
Chassis Retention
Bracket
Center Tab
5-11