Figure 7-1. T1000 As Chassis Front View - Tekelec T1000 Hardware Manual

How to Access T1000 AS FRUs
Procedure 7-4.
WARNING:
when working on electronic components.
1.
From the front of the frame, remove the # 12-24 Phillips screw from each
chassis retention bracket (see Figure 7-1). Do not remove the screws in the
frame adapter brackets.

Figure 7-1. T1000 AS Chassis Front View

Chassis Retention
Brackets (Remove these Screws)
2.
From the front of the frame, using the handles on the front top cover of the
chassis, pull forward until the release buttons on the inner arms of the slide
assemblies pop into the holes on each side.
DANGER: If the T1000 AS chassis is pulled too far out after the release
buttons are disengaged, the inner slide members (attached to the chassis)
could come out of the middle slide members (attached to the frame).
3.
This procedure is complete.
7-8
Slide T1000 AS Chassis Out from Frame
Always wear an ESD wrist strap grounded to the bench or frame
Handles
Captive Cover Screws
910-0095-001 Revision J November 2007
(Do NOT Remove
These Screws)