Figure 3-7. T1000 AS with Side Cable Management Arms
• Rear Cable Management Arm
The Rear Cable Management Arm attaches to the rear of the T1000 AS and
unfolds as the T1000 AS is slid out.
NOTE: Rear Cable Management Arm systems are no longer being
shipped with new T1000 AS installations.
Breaker Panels
Breaker panels are used to provide redundant power paths to T1000 AS units and
other equipment in a heavy duty frame in a DC environment.
Figure 3-8 shows the two breaker panels used to provide redundant power paths:
• An upper breaker panel, called BP-1
• A lower breaker panel, called BP-2
Each breaker panel has two sides: side A and side B. Each side has seven breakers,
although only certain breakers on each side are active (closed). The open position
of each breaker is marked by "O" and "|" marks the closed position.
910-0095-001 Revision J November 2007
Breaker Panels
3-11