How To Replace A T1000 As Chassis Fru - Tekelec T1000 Hardware Manual

How to Replace a T1000 AS Chassis FRU

Replacing a T1000 AS chassis requires that the slide assemblies be removed from
the failed chassis and attached to the replacement chassis. A replacement chassis
always contains fan assemblies and a removable media disk drive assembly.
However, it does not contain replacement PCI cards or hard disk drives unless
those parts are specified to be replaced when the Return Material Authorization
(RMA) is obtained.
Usually, when a T1000 AS chassis needs to be replaced, the PCI cards and hard
disk drive assemblies are removed from the failed T1000 AS chassis and placed in
the replacement chassis. It is recommended that the slide assemblies be attached
to the replacement chassis, using the procedure in this section, before moving the
PCI cards and hard disk drive assemblies.
Use the following procedure when Tekelec Customer Care Center has determined
that the T1000 AS chassis needs to be replaced.
SHOW ME: To view a video (with sound) that shows some steps of the
following procedure,
and data, be sure to read all the steps in the following procedure. For more
information about how to view this video, see "Programs Needed to View
Linked Documents" on page 1-4.
Procedure 7-13. Replace a T1000 AS Chassis FRU
1.
Ensure that the following have been done:
a. An RMA has been obtained (see Procedure B-1, "Obtaining an RMA," on
page B-2); for information about the part numbers to be supplied, see
"T1000 AS Chassis Part Number Information" on page B-16.
b. A spare part is available
2.
Inspect the unit and shipping container for indications of damage. If damage
is noted, contact the site supervisor or report damage to the carrier.
3.
Inventory the material in the shipping container and notify the site supervisor
or Tekelec Production Control of any discrepancies.
WARNING: Observe proper ESD procedures when handling the T1000
AS chassis. Always wear an ESD wrist strap connected to a grounded bench
or frame.
4.
Unpack the T1000 AS chassis from the shipping container and place the unit
on a secure workbench that is grounded for ESD protection. Save the
container and packing material for use in step 9.
910-0095-001 Revision J November 2007
click here. For personnel safety and to protect equipment
How to Replace T1000 AS FRUs
7-43