How To Power Up; How To Power Up A Heavy Duty Frame; How To Power Up Added T1000 As Unit In Dc Environment; How To Power Up A T1000 As Unit In An Ac Environment - Tekelec T1000 Hardware Manual

How to Power Up

How to Power Up
WARNING: Only a certified Tekelec test engineer should power up a system
after installation.
To power up, set the appropriate breakers to the ON position as described in one
of the following sections.
• "How to Power Up a Heavy Duty Frame" on page 6-14
• "How to Power Up Added T1000 AS Unit in DC Environment" on
page 6-14
• "How to Power Up a T1000 AS Unit in an AC Environment" on page 6-14
When the breakers that supply power to the T1000 AS unit are switched ON, the
unit will execute a power up sequence which includes a Power On Self Test
(POST). For information about initializing the software that runs on T1000 AS
chassis, refer to the application manuals included with your documentation.

How to Power Up a Heavy Duty Frame

In a Direct Current (DC) environment, to power up the equipment installed in the
heavy duty frame, turn ON (flip the switch toward the | indicator) all the
breakers that correspond to servers in the frame, as shown in
DC_BreakerSettings.pdf.

How to Power Up Added T1000 AS Unit in DC Environment

WARNING: Before powering up a server that has been added to an existing
frame in a DC environment, verify that the breakers that correspond to the
position where the server has been added are set to the OFF (O) position.
To power up an added server, turn ON (flip the switch toward the | indicator) the
breakers that correspond to the position where the server was added, as shown in
DC_BreakerSettings.pdf.

How to Power Up a T1000 AS Unit in an AC Environment

Use the following procedure to power up a T1000 AS unit in an AC environment.
WARNING: Before powering up, verify that the breakers that all rectifier
output breakers are set to the OFF (O) position.
6-14 910-0095-001 Revision J November 2007