How To Unpack A Rectifier And Conduct Inventory - Tekelec T1000 Hardware Manual

How to Unpack and Conduct Inventory
6.
Inspect the slide assemblies for indication of damage. If damage is noted, go
to step 7.
7.
If any damage is noted or parts are missing, contact Tekelec Customer Care
Center (see "Customer Assistance" on page 1-7).

How to Unpack a Rectifier and Conduct Inventory

When a rectifier is received, perform the following procedure:
Procedure 5-2.
1.
Inspect the shipping container for indication of damage. If damage is noted,
go to step 6.
DANGER: Moving this equipment requires two people. Improper
handling of this equipment may cause personnel injury or damage to the
equipment's internal components due to shock and vibration.
2.
Inventory the material in the shipping container. If any discrepancies are
noted, go to step 6.
WARNING: Observe proper ESD procedures when handling the T1000
AS chassis. Always wear an ESD wrist strap connected to a grounded bench
or frame.
3.
Unpack the rectifier from the shipping container and place the unit on a
secure workbench that is grounded for ESD protection.
4.
Remove the documentation from the container and store it where you can
access it for information about the rectifier. Discard the container and packing
material.
5.
Inspect the rectifier for indication of damage. If damage is noted, go to step 6.
6.
If any damage is noted or parts are missing, contact Tekelec Customer Care
Center (see "Customer Assistance" on page 1-7).
5-4
How to Unpack the Rectifier
910-0095-001 Revision J November 2007