How To Replace Hard Disk Drive Assemblies - Tekelec T1000 Hardware Manual

10.
Using a Phillips screwdriver tighten the captive fan retention screws on both
ends of the assembly.
11.
Plug the fan assembly cable into the connector on the midplane board.
12.
Close the chassis top cover.
13.
Tighten the captive screws to secure the top cover.
14.
Depending on how the fan assembly was accessed in step 2, return the T1000
AS chassis to its original position using one of the following procedures:
• Procedure 7-5, "Slide T1000 AS Chassis Back into Frame," on page 7-9
• Procedure 7-7, "Return a T1000 AS Chassis to the Frame," on page 7-15
15.
If requested, return the failed fan assembly to Tekelec. Arrange the return
shipment by using the procedures in "How to Arrange Return Shipping" on
page B-22.
16.
This procedure is complete.

How to Replace Hard Disk Drive Assemblies

Use the procedure in this section for either of the following purposes:
• To replace a failed hard disk drive
• To remove both hard disk drive assemblies from a failed T1000 AS chassis and
place them in a replacement T1000 AS chassis
SHOW ME: To view a video (with sound) that shows some steps of the
following procedure,
and data, be sure to read all the steps in the following procedure. For more
information about how to view this video, see "Programs Needed to View
Linked Documents" on page 1-4.
910-0095-001 Revision J November 2007
click here. For personnel safety and to protect equipment
How to Replace T1000 AS FRUs
7-23