How to Replace T1000 AS FRUs
Figure 7-9. Fan Assemblies and Connectors
Finger Holes
6.
Loosen the captive fan assembly retention screws on both ends of the fan
assembly. See Figure 7-9.
DANGER: After disconnecting the fan assembly cable and before
removing the fan assembly, allow sufficient time (about three minutes) for
the fans to quit rotating. Fans will continue to rotate after this interval
because of the airflow from the other fan assembly. The continued rotation
will not cause injury.
7.
Insert fingers into the finger holes on top of each fan assembly and lift the fan
assembly up and out of the chassis.
8.
Set the fan assembly aside.
9.
Lower the new fan assembly inserting the guide edges into the chassis fan
guides (black).
7-22
03_ts_fan-connector-location
Fan Assembly
Connectors
TekServer Front View
910-0095-001 Revision J November 2007
Fan Assembly
Retention Screws