Tekelec T1000 Hardware Manual page 142

How to Replace T1000 AS FRUs
15.
From the rear of the frame attach the cable to the PCI card.
16.
Do one of the following:
• If this procedure is being performed to replace a failed PCI card, skip to
the next step.
• If this procedure is being performed to move PCI cards from a failed
T1000 AS chassis to the replacement T1000 AS chassis, repeat step 4
through step 15 for each PCI card to be moved.
17.
Replace the rear cover on the T1000 AS chassis. Slide the guide slots over and
past the screws loosened in step 6 on page 7-39.
18.
Tighten the four guide screws attaching the rear top cover to the T1000 AS
chassis.
19.
Tighten the captive fastener at the rear of the cover.
20.
Close the chassis top cover.
21.
Tighten the captive screws to secure the top cover.
22.
Do one of the following:
• If this procedure is being performed to move PCI cards from a failed
T1000 AS chassis to the replacement T1000 AS chassis, skip to the next
step.
• If this procedure is being performed to replace a failed PCI card, do the
following:
— Attach the label that was received with the replacement PCI card on
— Return the failed PCI card to Tekelec, using the shipping contained in
23.
This procedure is complete.
7-42
the appropriate section of the PCI card label located on the left side of
the T1000 AS chassis (for a diagram of the label, see Figure 7-20 on
page 7-38; for placement of this label on the T1000 AS chassis, see
Figure B-7 on page B-10).
which the replacement PCI card was received. Arrange the return
shipment by using the procedures described in Appendix B,
"Hardware Repair and Return."
910-0095-001 Revision J November 2007