How To Anchor The Hd Frame To The Floor - Tekelec T1000 Hardware Manual

How to Install a T1000 AS Frame
Next, perform one of the following procedures, depending on the anchoring
method you choose:
• Procedure 4-5, "Anchor the Frame to the Slab Beneath the Raised Floor," on
page 4-11
• Procedure 4-6, "Anchor Frame to Raised Floor with Support Channel," on
page 4-14
• Procedure 4-7, "Anchor Frame with Support Channel/Spring Nut," on page
4-16

How to Anchor the HD Frame to the Floor

See the following sections for instructions on anchoring heavy duty frames to the
floor. These procedures are for typical installation sites with slab (concrete) floors
and raised floors. You might have to accommodate these procedures to the
unique features of your site. Depending upon your floor, use the procedure in one
of the following sections:
• Anchoring directly to a slab floor (see "How to Anchor Frame to Slab Floor"
on page 4-6)
• Anchoring to a slab floor beneath a raised floor (see "How to Anchor to
Concrete Floor Under a Raised Floor" on page 4-10)
• Anchoring to a raised floor using washer and nut (see "How to Anchor on
Raised Floor Using Support Channel" on page 4-13)
• Anchoring to a raised floor using a unistrut (see "How to Anchor on Raised
Floor Using Support Channel with Spring Nut" on page 4-16)
WARNING: Before drilling holes in any flooring, verify with facilities
personnel that the area is free of gas or water pipes, ventilation plenum, and
electrical wiring conduits.
How to Anchor Frame to Slab Floor
Use the procedure in this section to anchor the frame directly to a concrete slab
floor. If you are anchoring to a raised floor above a slab floor, see "How to Anchor
to Concrete Floor Under a Raised Floor" on page 4-10. Always get permission
from facility personnel before drilling any holes for HD frame installation.
Figure 4-2 shows the components of the Anchor Assembly used for a slab floor.
4-6 910-0095-001 Revision J November 2007