How To Return A T1000 As Chassis To The Frame - Tekelec T1000 Hardware Manual

How to Access T1000 AS FRUs
9.
Place the chassis on a grounded bench and attach the ground wrist strap to
the bench.
10.
This procedure is complete.
Continue with one of the following procedures:
• If the chassis has been removed from the frame to a workbench in order to
replace one of the following FRUs, go the procedure shown:
— Procedure 7-9, "Replace a Fan Assembly," on page 7-20
— Procedure 7-10, "Replace a Hard Disk Drive Assembly," on page 7-24
— Procedure 7-11, "Replace a Removable Media Disk Drive Assembly," on
page 7-34
— Procedure 7-12, "Replace a PCI Card," on page 7-37
• If the T1000 AS chassis is being replaced, but the hard drives and/or the PCI
cards from the failed chassis are to be used in the replacement chassis, go to:
— Procedure 7-13, "Replace a T1000 AS Chassis FRU," on page 7-43
— Then go to either of both of the following procedures:
–Procedure 7-10, "Replace a Hard Disk Drive Assembly," on page 7-24
–Procedure 7-12, "Replace a PCI Card," on page 7-37
• If the T1000 AS chassis is being replaced, and it was ordered with
replacements for the hard drives and PCI cards, go to Procedure 7-13,
"Replace a T1000 AS Chassis FRU," on page 7-43.
When these procedures have been finished, return the chassis to the frame, using
Procedure 7-7, "Return a T1000 AS Chassis to the Frame," on page 7-15.

How to Return a T1000 AS Chassis to the Frame

Perform the procedure in this section when it is time to return the T1000 AS
chassis to the frame for one of the following reasons:
• A T1000 AS chassis FRU is being replaced and the following procedures have
been performed:
— Procedure 7-6, "Remove a T1000 AS Chassis from Frame," on page 7-10
— Procedure 7-13, "Replace a T1000 AS Chassis FRU," on page 7-43. One of
the following procedures may also have been performed:
–Procedure 7-10, "Replace a Hard Disk Drive Assembly," on page 7-24
–Procedure 7-12, "Replace a PCI Card," on page 7-37
7-14 910-0095-001 Revision J November 2007