Figure 4-4. Anchor Assembly For Raised Floor Over Concrete - Tekelec T1000 Hardware Manual

How to Install a T1000 AS Frame
How to Anchor on Raised Floors
To anchor a frame on a raised floor, use the procedure in one of the following
sections :
• "How to Anchor to Concrete Floor Under a Raised Floor" on page 4-10
• "How to Anchor on Raised Floor Using Support Channel" on page 4-13
• "How to Anchor on Raised Floor Using Support Channel with Spring Nut"
on page 4-16
How to Anchor to Concrete Floor Under a Raised Floor
Use the following procedure to anchor a frame on a raised floor to the concrete
slab beneath the raised floor. Figure 4-4 shows the components of the anchor
assembly used for a concrete floor beneath a raised floor.

Figure 4-4. Anchor Assembly for Raised Floor Over Concrete

Note: When an anchor assembly
is used on a raised floor, the anchor
assembly must be disassembled
and the correct length of threaded
rod of the proper diameter must be
used for the floor height
requirement.
Finger tighten nuts above
raised floor before tightening
nut directly below the raised floor
Small steel
washer
Nylon shoulder
washer
Concrete floor
4-10
Large fiber
washer
Hold-down plate
Nylon shoulder
washer
Large washer
Small steel
washer
Nylon collar
5/8 inch
Twist off nut
Torque nut
(red plastic
cover)
Frame floor
Isolation pad
Raised floor
5/8 inch nut
Isolation pad
Threaded rod
(see note)
Raised floor
Concrete floor
Twist off nut
Torque nut
(red plastic
cover)
Metal sleeve
(inside)
Expansion
sleeve
Cone nut
anchor_rsdflr
910-0095-001 Revision J November 2007
Sub-floor
marking
tool
Frame floor
Anchor assembly
with threaded rod