Network Assumptions - Tekelec T1000 Hardware Manual

Table C-4. Interface Functions Required for MPS (Continued)
Interface Function Protocol
Dial-up PPP server TCP/IP
on Sync Network
Dial-up PPP server TCP/IP
on Sync Network
Dial-up PPP server TCP/IP
on Sync Network
Main DSM TCP/IP
Network
Main DSM TCP/IP
Network
Backup DSM TCP/IP
Network
Backup DSM TCP/IP
Network
Sync Network TCP/IP
Sync Network TCP/IP
* These are generally visible outside of the immediate MPS area and they will
pass through routers and firewalls

Network Assumptions

The MPS network route and gateway implementation conforms to the following:
• Four individual networks are required. Three of these networks are
internal to the MPS system and should not need to be changed.
• MPS is configured to listen for Routing Information Protocol (RIP)
broadcasts but does not send out any routing updates.
• Individual interfaces are configured with default IP addresses at the time
of EPAP or ELAP initialization. IP addresses are assigned as part of the
manufacturing procedure and can be changed at initialization if required.
See "Network Configuration" on page C-8 to implement a change.
• No use of virtual LANs, custom subnets, or other routing parameters are
used that could conflict with the customer network.
• Matching of the interfaces to the external destinations is implemented
using a default route.
910-0095-001 Revision J, November 2007
Preliminary
Speed
Netra Assigned to
Tekserver (Netra/Tekserver)
PPP modem MPS Server A Client PPP
serial port
PPP modem MPS Server
B PPP serial port (ipdptp0)
PPP modem MPS Server B Client PPP
serial port
10/100BaseT MPS Server A
Gigabit (qfe0 port/interface eth1)
10/100BaseT MPS Server B
Gigabitt (qfe0 port/interface eth1)
10/100BaseT MPS Server A
Gigabitt (qfe1 port/interface eth2)
10/100BaseT MPS Server B
Gigabitt (qfe1 port/interface eth2)
10/100BaseT MPS Server A
Gigabitt (qfe2 port/interface eth3)
10/100BaseT MPS Server B
Gigabitt (qfe2 port/interface eth3)
Network Assumptions
Assigned to
(Netra/Tekserver)
MPS Server A Client PPP
serial port
MPS Server B PPP serial
port (ipdptp0)
MPS Server B Client PPP
serial port
MPS Server A
(qfe0 port/interface eth1
MPS Server B
(qfe0 port interface eth1)
MPS Server A
(qfe1 port/interface eth2)
MPS Server B
(qfe1 port/interface eth2)
MPS Server A
(qfe2 port/interface eth3
MPS Server B
(qfe2 port/interface eth3
C-7