Table of Contents
Advertisement
How to Access T1000 AS FRUs
How to Remove T1000 AS Chassis from a Frame
It may be necessary to remove a T1000 AS chassis from its frame for either of the
following reasons:
• To move the chassis to a workbench where one or more of the following FRUs
can be replaced (be sure that a replacement FRU is on hand):
— Fan assemblies
— Hard disk drive assemblies
— Removable media disk drives assembly
— PCI cards
NOTE: Alternatively, these FRUs can be replaced by sliding the T1000
AS chassis partway out of the frame, using Procedure 7-4, "Slide T1000
AS Chassis Out from Frame," on page 7-8.
• To remove and replace a failed T1000 AS chassis.
NOTE: If the hard disk drives and PCI cards in the failed chassis do
not need to be replaced, they can be removed from the failed T1000 AS
chassis and placed in the replacement chassis. Moving the disk drives
in this way allows data to be preserved.
Use the following procedure to remove a T1000 AS chassis from the frame.
SHOW ME: To view a video (with sound) that shows some steps of the
following procedure, click here. For personnel safety and to protect equipment
and data, be sure to read all the steps in the following procedure. For more
information about how to view this video, see "Programs Needed to View
Linked Documents" on page 1-4.
Procedure 7-6.
WARNING: This procedure CANNOT be performed while the T1000 AS
chassis is powered on. Never power OFF a T1000 AS chassis until the
application software and platform operating system (OS) are shut down. If
possible, use the procedures in the application manual for a "soft
shutdown." If the application interface is not operating or is not accessible,
a hard shutdown (turning OFF the breakers) is sometimes required. Contact
Tekelec Customer Care Center before doing a hard shutdown.
WARNING:
frame when working on electronic components.
7-10
Remove a T1000 AS Chassis from Frame
Always wear an ESD wrist strap grounded to the bench or
910-0095-001 Revision J November 2007
Advertisement
Table of Contents
