Figure 6-6. Ground Cable Attachment Locations For T1000 As In Ac Environment - Tekelec T1000 Hardware Manual

How to Connect Frame Ground and Logic Ground
Figure 6-6. Ground Cable Attachment Locations for T1000 AS
Rectifier System Rear View
Chassis ground
3.
This procedure is complete.
How to Verify the Ground in an AC Environment
Use the following procedure to o verify ground in an AC environment.
Procedure 6-7.
1.
Take the black lead of a VOM and insert it into the ground post on the AC
source plug/outlet being tested.
2.
Take the red lead of the VOM and insert it into one of the hot sides of the
plug/outlet. The meter should now read 208 VDC.
3.
While keeping the black lead in place, remove the red lead from the branch it
was inserted into in step 2 and insert it into the other branch of the
outlet/plug. Again the meter should read 208 VDC.
4.
This procedure is complete.
6-12
in AC Environment
PWR B
LOGIC GND
CLK
USB A
SERIAL
VGA
B
Verify AC ground
Chassis ground
PWR A
PCI 8 PCI 7 PCI 6 PCI 5 PCI 4 PCI 3 PCI 2 PCI 1
TekServer Rear View
910-0095-001 Revision J November 2007
AC grounding
cable
05_ts_ac_chassis_gnd