Figure 5-6. Slide Assembly Outer Member - Tekelec T1000 Hardware Manual

7.
Loosely attach the rear slide assembly brackets with four #10-32 locknuts to
the outer slide members. This makes it easier when attaching the brackets to
the frame adapters or frames. See Figure 5-6. The front slide assembly brackets
are mounted at the factory.

Figure 5-6. Slide Assembly Outer Member

8.
Attach the front and back slide assembly brackets on each slide assembly with
four #12-24 Phillips screws to the four frame adapters installed in step 6. Both
slide assemblies are identical. Viewed from the rear of the frame, orient the
slide assemblies with the rear detent latches at the bottom on the left slide
assembly and at the top on the right slide assembly. See Figure 5-7 on page
5-10 for positioning.
NOTE: The inner slide members are shown inserted into the middle slide
member in this view for clarity only. In the following steps the inner slide
members will be attached to the T1000 AS chassis and inserted into the
middle slide members.
910-0095-001 Revision J November 2007
Inner Slide
Front Slide Assembly
Bracket
Middle Slide
#10-32 Locknuts
Rear Slide Assembly
Bracket
How to Install an Individual T1000 AS Unit
5-9