Figure 51: Slide Assembly Inner Member Mounting - Tekelec 1100 Hardware Manual

How to Install Hardware in an Existing Frame
9. Tighten the four #10-32 locknuts on each of the rear slide assembly brackets.
10. Pull the middle slide members from the outer slide members until the rear detents latch.
This allows access to the release buttons when inserting the chassis with attached inner slide
members.
11. At the workbench, attach the inner slide members that were separated in
to both sides of the T1100AS chassis with four #10-32 Phillips screws each.
Orient the inner slide members with the roller bearings outward and the center tabs toward
the front of the chassis. See
view of the inner member on the left side of the T1100AS chassis. The inner slide member
orientation on the right side of the chassis is similar.

Figure 51: Slide Assembly Inner Member Mounting

76
Figure 51: Slide Assembly Inner Member Mounting
Hardware Manual
Step 4
on page 76 for a
910-2969-001 Revision K, June 2009
on page 72,