3.
Using a Phillips screwdriver, loosen the captive spring-loaded screws on the
T1000 AS chassis top cover until they are free. See Figure B-6 for locations.
Figure B-6. T1000 AS Front Top Cover
Chassis Retention
Brackets (Remove these Screws)
4.
Grasp the handles on the front top cover of the chassis and lift up until the
constant torque hinges support the weight of the cover and the four attached
disk drives located under the cover.
5.
Figure B-4 shows the location of the removable media disk drive assembly
part label.
6.
Close the chassis top cover.
7.
Tighten the captive screws to secure the top cover.
8.
From the front of the frame, simultaneously press the round release buttons
and slowly push the chassis into the frame while observing the cables to avoid
binding or stretching.
910-0095-001 Revision J November 2007
Handles
Captive Cover Screws
How to Locate T1000 AS Part Numbers
(Do NOT Remove
These Screws)
B-9