Table of Contents
Advertisement
Customer-Supplied Information
Customer-Supplied Information
The customer's network administrator provides the following information:
1. Two IP addresses on the provisioning network
2. Netmask of the provisioning network
3. Default router on the provisioning network
IP Address Assignment
The provisioning network requires two IP addresses, one for each MPS Server.
The IP addresses are provided by the customer network administrator.
The main DSM Network, the backup DSM Network and the Synchronization
Network addresses are pre-set prior to customer delivery. If there is a conflict in
the customer's numbering plan with the pre-set addresses, the pre-set addresses
can be changed.
The addresses require private class "C" network addresses as defined in RFC
1597 and RFC 1918. These networks are not routed (not visible to any external
networks).
The third octet for each ELAP or EPAP Sync network address is set to .2 as the
default. It can be changed if necessary. If you change this octet value, follow the
instructions in "Configure ELAP or EPAP Sync Network" in the ELAP
Administration Manual or the EPAP Administration Manual.
The fourth octet of the address is selected as follows:
• If the ELAP or EPAP is configured as ELAP A or EPAP A, the fourth octet
has a value of 100.
• If the ELAP or EPAP is configured as ELAP B or EPAP B, the fourth octet
has a value of 200.
TEKELEC recommends that the addresses range between 192.168.1.0 and
192.168.255.0. The netmask of these networks must be 255.255.255.0. Table C-1
depicts the IP address allocation for the DSM Network.
Table C-1.
IP Range
xxx.xxx.xxx.1 - xxx.xxx.xxx.25
xxx.xxx.xxx.100
xxx.xxx.xxx.200
xxx.xxx.xxx.210 - xxx.xxx.xxx.215
C-4
— Draft —Preliminary
IP Address for the DSM Network
Function
DSM Interfaces (One IP address per card)
MPS Server A IP Address
MPS Server B IP Address
Local Access IP address (on Backup DMS network)
910-0095-001 Revision J, November 2007
Advertisement
Table of Contents
