Introduction - Tekelec T1000 Hardware Manual

Introduction

Introduction
Depending on the applications that run on them, T1000 AS hardware systems are
delivered in one of the following ways:
• Integrated applications
Most applications that run on T1000 AS systems are designed to be
integrated with features that run on a Signal Transfer Point (STP). T1000
AS systems for these applications run in a Direct Current (DC)
environment and are delivered in one of the following ways:
— For all applications, the initial installation of the T1000 AS hardware
— Some applications allow a single T1000 AS unit to be added to a heavy
For more information about these T1000 AS hardware systems, see "T1000
AS Hardware System in a DC Environment" on page 3-3.
• Non-integrated applications
Applications (such as provisioning applications or network management
applications) that do not need to integrate with STP features may not
require a DC environment. If an application is designed to run in an
Alternating Current (AC) environment, a single T1000 AS unit is delivered
along with equipment that converts AC power to DC power.
For more information, see "T1000 AS Hardware System in an AC
Environment" on page 3-5.
To determine which environments are supported by the applications that run on
the T1000 AS systems, refer to the applications documentation.
This chapter provides an overview of T1000 AS hardware systems in each of the
possible environments and an overview of each of the components that can be
part of a T1000 AS hardware system.
3-2
system consists of one or more T1000 AS units, along with breaker
panels and Ethernet communication equipment, already installed by
Tekelec manufacturing in a heavy duty frame.
duty frame that has been previously installed and already contains
one to four T1000 AS units. To view the maximum configuration
allowed, refer to the DC assembly drawing.
910-0095-001 Revision J November 2007