Table of Contents
Advertisement
How to Access T1000 AS FRUs
A T1000 AS FRU can be accessed in one of the following ways:
WARNING:
when working on electronic components.
• Without moving the chassis from its position in the frame. The air filter can be
accessed this way; see "How to Replace an Air Filter" on page 7-18).
• By sliding the chassis partway out of the frame (see "How to Slide T1000 AS
Chassis Out from Frame" on page 7-7). This method can be used to access one
or more of the following:
— Fan assembly
— Hard drive assembly
— Removable media drives assembly
— PCI cards
• By removing the chassis from the frame and placing it on a workbench (see
"How to Remove T1000 AS Chassis from a Frame" on page 7-10)
— This method must be used to access the T1000 AS chassis for replacement
— This method may be used to access one or more of the following:
–Fan assembly
–Hard drive assembly
–Removable media drives assembly
–PCI cards
How to Slide T1000 AS Chassis Out from Frame
The following FRUs can be replaced without removing the T1000 AS chassis
entirely out of the frame:
• Fan assemblies
• Hard disk drive assemblies
• Removable media disk drives assembly
• PCI cards
SHOW ME: To view a video (with sound) that shows some steps of the
following procedure, click here. For personnel safety and to protect equipment
and data, be sure to read all the steps in the following procedure. For more
information about how to view this video, see "Programs Needed to View
Linked Documents" on page 1-4.
910-0095-001 Revision J November 2007
Always wear an ESD wrist strap grounded to the bench or frame
How to Access T1000 AS FRUs
7-7
Advertisement
Table of Contents
