How to Replace T1000 AS FRUs
Figure 7-21. Chassis Rear Cover Views
7.
Using a #1 Phillips screwdriver remove the retention screw located at the top
of the PCI faceplate.
NOTE: If a PCI card is being added, remove the PCI filler plate. When
adding or removing cards apply the correct label to the PCI configuration
label. Labels are shipped with PCI cards indicating card type and CLEI
code.
8.
Remove the PCI card by grasping with both hands and lifting until the card is
disconnected from the card connector. See Figure 7-22.
7-40
Cover In Place
Guide Screws
Captive
Fastener
Cover Removed
PCI Card Type/Slot
Assignment Lable
910-0095-001 Revision J November 2007