Figure 7-22. Pci Cards And Slot Assignments - Tekelec T1000 Hardware Manual

Figure 7-22. PCI Cards and Slot Assignments

Slot 1
9.
Place the card in an approved ESD storage bag or container.
10.
Store the card for later return or other disposition.
NOTE: If PCI cards are to be discarded they must be scrapped in
accordance with accepted environmental recycling procedures.
11.
Remove the replacement PCI card from the ESD container.
12.
Inspect the replacement PCI card for damage and correct card type. Make sure
the replacement card has the same information on the inventory label as the
card that was removed. Card labels are located on the side of the card (see
Figure 7-19 on page 7-38).
13.
Insert the replacement PCI card into the correct card connector by grasping
with both hands and pressing firmly down while maintaining alignment with
the connector.
NOTE: When inserting full-length PCI cards align with the correct slot
guide on the bulkhead toward the front of the chassis.
14.
Using a #1 Phillips screwdriver replace the retention screw located at the top
of the PCI faceplate.
910-0095-001 Revision J November 2007
PCI Card
Face Plate
Slot 8
How to Replace T1000 AS FRUs
PCI Connectors
r d
i_ c a
s _ p c
0 3 _ t
7-41