How To Replace Removable Media Disk Drives - Tekelec T1000 Hardware Manual

20.
Tighten the captive screws to secure the top cover.
21.
Do one of the following:
• If this procedure is being performed to move hard disk drive assemblies
from a failed T1000 AS chassis to the replacement T1000 AS chassis, skip
to the next step.
• If this procedure is being performed to replace a failed hard disk drive, do
the following:
— Attach the label that was received with the replacement hard disk
— Return the failed hard disk drive assembly to Tekelec, using the
22.
Depending on how the hard disk drive assembly was accessed in step 4,
return the T1000 AS chassis to its original position using one of the following
procedures:
• Procedure 7-5, "Slide T1000 AS Chassis Back into Frame," on page 7-9
• Procedure 7-7, "Return a T1000 AS Chassis to the Frame," on page 7-15
23.
Refer to applications documentation to determine whether additional steps
are required.
24.
This procedure is complete.

How to Replace Removable Media Disk Drives

Use the procedure in this section to replace the assembly that contains two
removable media disk drives (also called CDRW/DVD drives). This assembly is
located on the underside of the front top cover.
910-0095-001 Revision J November 2007
drive assembly on the base unit/hard disk label located on the front of
the left side of the T1000 AS chassis (for label placement, see
Figure 7-14 on page 7-31).
shipping contained in which the replacement hard disk drive
assembly was received. Arrange the return shipment by using the
procedures described in "How to Arrange Return Shipping" on
page B-22.
How to Replace T1000 AS FRUs
7-33