How To Replace A Rectifier - Tekelec T1000 Hardware Manual

How to Replace a Rectifier

Procedure 7-2.
For information about replacing a rectifier module, refer to the documentation
that was shipped with the rectifier
How to Replace a Rectifier
In an Alternating Current (AC) environment, a rectifier is used to convert the AC
power of the environment to Direct Current (DC) power needed by the T1000 AS
unit. If the entire rectifier needs to be replaced, perform the following procedure.
Procedure 7-3.
1.
Shut down the application that runs on the T1000 AS unit
2.
Turn all the breakers in the rectifier to the OFF position.
3.
Unplug the rectifier from the environment's power source.
4.
Remove the cables from the back of the rectifier (refer to
AC_InterconnectDiagram.pdf).
DANGER: Moving this equipment requires two people. Improper
handling of this equipment may cause personnel injury or damage to the
equipment's internal components due to shock and vibration.
5.
Replace the rectifier (refer to the documentation that was shipped with the
rectifier).
NOTE: Ensure a gap of 3/4 inches above and below the rectifier to allow
for sufficient air flow.
6.
Connect the cables to the replacement rectifier (refer to
AC_InterconnectDiagram.pdf).
7.
Plug the rectifier back into the environment's power source.
8.
Turn all the breakers in the rectifier to the ON position.
9.
This procedure is complete.
7-6
Replace a Rectifier Module
Replace a Rectifier
910-0095-001 Revision J November 2007