Printers; Procedure C-1. Configure Modem With Script - Tekelec T1000 Hardware Manual

If the remote dial-in serial port is not functional at one EAGLE 5 ISS site, dialing
into the remote EAGLE 5 ISS site and connecting back to the functional MPS at the
failed EAGLE 5 ISS site will allow remote recovery.
Modem Configuration
To simplify configuring the modem to the setting described in the previous
section ""Dial-in Capability," use the script
/opt/TKLCplat/bin/modem_setup. (also can be executed from
Application GUI)
This script supports five modems:
• Motorola V.3600
• US Robotics X2 Sportster External
• US Robotics V.90 Sportster External
• Multitech MT5634ZBA (no long supported)
• 3Com US Robotics Courier 56k V-Everything
NOTE: This script does NOT support any other modems.
Set up the modem using this script with the following procedure.

Procedure C-1. Configure Modem with Script

1.
Attach the modem to MPS server B, port a001 of the serial expansion board
using an appropriate cable. (This cable must be wired straight through, all 25
pins wired.)
2.
Apply power to the modem.
3.
Run the script from a user shell account on MPS server B, such as epapdev or
elapdev. Here is a sample execution of the script:
$ /opt/TKLCplat/bin/modem_setup tmodem
connected
Setting up Motorola V.3600 modem.
Done setting up Motorola modem.

Printers

Printers are not supported on the MPS systems.
910-0095-001 Revision J, November 2007
Preliminary
Serial Communication
C-11