Figure 7-17. T1000 As Front Top Cover - Tekelec T1000 Hardware Manual

WARNING:
frame when working on electronic components.
• Procedure 7-4, "Slide T1000 AS Chassis Out from Frame," on page 7-8
• Procedure 7-6, "Remove a T1000 AS Chassis from Frame," on page 7-10
4.
Using a Phillips screwdriver, loosen the captive spring-loaded screws on the
T1000 AS chassis top cover until they are free. See Figure 7-10 for locations.

Figure 7-17. T1000 AS Front Top Cover

Chassis Retention
Brackets (Remove these Screws)
5.
Grasp the handles on the front top cover of the chassis and lift up until the
constant torque hinges support the weight of the cover and the four attached
disk drives located under the cover.
6.
Unplug the two flat 40-position IDE data cables and the single power cable
from the drive adapter board. With a permanent marker, mark the IDE cable
that is attached to the top IDE connector on the board. See Figure 7-18.
910-0095-001 Revision J November 2007
Always wear an ESD wrist strap grounded to the bench or
Handles
Captive Cover Screws
How to Replace T1000 AS FRUs
(Do NOT Remove
These Screws)
7-35