Introduction; How To Unpack And Conduct Inventory; How To Unpack A T1000 As Unit And Conduct Inventory - Tekelec T1000 Hardware Manual

Introduction

Introduction
This chapter describes how to unpack install individual T1000 AS hardware
system components and install them in frames that are already installed at
customer sites in the following situations:
• In a Direct Current (DC) environment, some applications allow one or
more additional T1000 AS units to be ordered and delivered after the
initial T1000 AS frame has already been installed. For an overview of this
environment, see "T1000 AS Hardware System in a DC Environment" on
page 3-3.To view the maximum configuration allowed for your
application, refer to the
• In an Alternating Current (AC) environment, both the T1000 AS unit and
the rectifier are installed in a customer's frame at the customer site. (This
chapter does not describe how to install the frame in an AC environment.)
For information about installing a T1000 AS hardware system that is delivered in
a frame, see Chapter 4, "How to Install a T1000 AS Frame."

How to Unpack and Conduct Inventory

To unpack and conduct inventory, see one of the following sections:
• "How to Unpack a T1000 AS Unit and Conduct Inventory" on page 5-2
• "How to Unpack a Rectifier and Conduct Inventory" on page 5-4

How to Unpack a T1000 AS Unit and Conduct Inventory

When the individual T1000 AS unit arrives, perform the following procedure:
Procedure 5-1.
1.
Inspect the shipping container for indication of damage. If damage is noted,
go to step 7.
DANGER: Moving a T1000 AS chassis requires two people. Each T1000
AS chassis weighs approximately 30 kg (65 lbs) and may cause personnel
injury or damage to the internal components due to shock and vibration if
not handled properly.
2.
Inventory the material in the shipping container. If any discrepancies are
noted, go to step 7.
5-2
DC assembly
Unpack a T1000 AS Chassis
drawing.
910-0095-001 Revision J November 2007