Figure B-8. Base Unit/Hard Disk Label on T1000 AS Chassis
Procedure B-4. How to Locate RMA Numbers for Hard Disk
1.
Request that Tekelec Customer Care Center assist you in determining whether
the hard disk drive assembly that needs to be replaced is in position "A" or
position "C".
2.
Determine whether the required Hard Disk area (A or C) of the base
unit/hard disk label on the front of the left side of the T1000 AS chassis can be
viewed from the side of the frame without sliding the chassis out from the
frame. See Figure B-7 for the placement of the label on the chassis and
Figure B-8 for the location of the Hard Disk information on the label.
3.
If the necessary Hard Disk area of the base unit/hard disk label shown in
Figure B-8 on page B-11 can be viewed, report the requested information from
the label, and skip to step 10. Otherwise, perform the remaining steps.
WARNING:
frame when working on electronic components.
4.
From the front of the frame, remove the # 12-24 Phillips screw from each
chassis retention bracket (see Figure B-9). Do not remove the screws in the
frame adapter brackets.
910-0095-001 Revision J November 2007
Drive Assembly
Always wear an ESD wrist strap grounded to the bench or
How to Locate T1000 AS Part Numbers
03_ts_pci_config_label
B-11