Figure 5-8. Slide Assembly Inner Member Mounting - Tekelec 1100 Hardware Manual

Figure 5-8. Slide Assembly Inner Member Mounting

12.
Lift the T1100 AS chassis with the attached inner slide members and carefully
insert the inner slide member rollers into the middle slide members that were
previously mounted on the frame.
13.
Simultaneously press the release buttons on the inner slide members once
when the buttons encounter the middle slide members.
NOTE: The inner slide members will travel approximately two more
inches and the release buttons will detent into the round cutouts of the
middle slide members. This is the standard open position of the slides.
14.
Attach the Cable Management System.
For Side Cable Management Systems, attach the cable management arms to
the rear of the frame using the bolts included with the system. Be sure that the
arms can slide in toward the T1100 AS.
5-10
Preliminary
Release
Button
Four #10-32
Phillips Screws
Inner Slide Member
How to Install Hardware in an Existing Frame
Chassis
Roller Bearings
Chassis Retention
Bracket
910-2969-001 Revision H, February 2007
Center Tab