T1000 AS FRUs
Table 7-1 shows the T1000 AS components that have been designed to be
replaceable in the field. Most of these components are located for easy access; they
can be replaced without completely removing them from the frame. In addition,
some of them can even be replaced without needing to shut off power to the
T1000 AS chassis.
WARNING: When you need to replace a FRU for which the power must be
shut off, always first attempt to perform a soft shutdown of the application
systems (refer to the application manual).
Table 7-1.
FRU
Air filters
Fan assemblies
Hard drive assemblies
Removable media
drives assembly
PCI cards
T1000 AS chassis*
* When a T1000 AS chassis needs to be replaced, the hard drive assemblies and the PCI cards can
be moved from the failed chassis to the replacement chassis. Moving the hard drive assemblies
from the failed server to the replacement server allows data to be preserved.
Tools Required
The following tools are required for performing procedures in this chapter:
• Safety glasses
• # 0 Phillips screwdriver
• # 1 Phillips screwdriver
• # 3 Phillips screwdriver
• 3/8 inch nutdriver
• Volt Ohm Meter (VOM)
910-0095-001 Revision J November 2007
T1000 AS Field Replaceable Units (FRUs)
T1000 AS Power
State Required
before
Replacement
ON or OFF
ON or OFF
OFF
OFF
OFF
OFF
T1000 AS Location
Behind front fascia
Under front lid
Under front lid
Under front lid
Under rear lid
Entire unit
Tools Required
Access
Remove front fascia while
chassis in frame
Open front top cover after
either:
•
Sliding chassis
out
•
Removing chassis
from frame
Open front top cover after
removing chassis from
frame
Remove chassis from frame
7-3