Table of Contents
Advertisement
Safety Information
DANGER: Do not wear metal, chains, rings, watches, or jewelry or carry
exposed metal, keys or tools in pockets when working on system equipment or
other related electrostatic-sensitive components. Always wear a wrist strap or
other electrostatic protection when handling printed circuit boards and other
electrostatic-sensitive devices.
WARNING: Do not leave or allow unused metal objects, such as screws or
washers, to remain anywhere within the equipment. Remove all unused
material from the equipment
WARNING: Do not allow any metal shavings to remain in the equipment
area. Metal Shavings may result from over tightened screws or bolts. These
small metal particles are hazardous to electronic equipment.
Be careful not to over tighten screws or bolts.
WARNING: Do not use tie wrAS on or above the top traverse arms on a
frame. Always trim tie wrap flush and turn the trimmed tie wrap to the rear of
the cable.
CAUTION: All personnel associated with the installation of these systems
must adhere to all safety precautions and use required protection equipment, to
avoid the possibility of injury to personnel, service degradation, and/or service
interruption.
CAUTION: These systems have redundant power supplies to allow service
during normal maintenance. When repairs require a total power disconnect,
both input supply sources must be disconnected. This causes service
interruption and takes down the systems.
CAUTION: This equipment has a connection between the earthed conductor
of the DC supply circuit and the earthing conductor.
CAUTION: The Branch Circuit Overcurrent Protection shall be rated
minimum -48V, maximum 40A.
CAUTION: Equipment is to be installed in restricted access areas in
accordance with articles 110-16, 110-17, and 110-18 of the National Electric Code,
ANSI/NFPA 70.
910-0095-001 Revision J November 2007
2-3
Advertisement
Table of Contents
