Figure 7-4. Chassis Retention Hardware - Tekelec T1000 Hardware Manual

6.
From the front of the frame, remove the # 12-24 Phillips screw from each of the
chassis retention brackets (see Figure 7-4). Do not remove the screws in the
frame adapter brackets.

Figure 7-4. Chassis Retention Hardware

Chassis Retention
Brackets (Remove these Screws)
7.
From the front of the frame, using the handles on the front top cover of the
chassis, pull the T1000 AS chassis forward until the release buttons on the
inner arms of the slide assemblies pop into the holes on each side.
DANGER: Moving a T1000 AS chassis requires two people. Each T1000
AS chassis weighs approximately 30 kg (65 lbs) and may cause personnel
injury or damage to the internal components due to shock and vibration if
not handled properly.
8.
Simultaneously depress the chassis release buttons on each side and slowly
pull the chassis forward until the chassis and attached inner slide members
are completely free of the slide assemblies. See Figure 7-2 on page 7-12 for
locations of the release buttons.
910-0095-001 Revision J November 2007
Handles
Captive Cover Screws
How to Access T1000 AS FRUs
(Do NOT Remove
These Screws)
7-13