Figure 7-18. Removable Media Disk Drive Adapter Assembly - Tekelec T1000 Hardware Manual

How to Replace T1000 AS FRUs

Figure 7-18. Removable Media Disk Drive Adapter Assembly

NOTE: T1000 AS removable media drives and adapter are considered one
FRU. Remove and replace the entire adapter assembly including both
removable media drives.
7.
Using the #1 Phillips screwdriver, loosen but do not remove the four 6-32 pan
head screws that connect the slimline CDRW/DVD drive adapter assembly to
the standoffs on the front lid.
8.
Move the slimline CDRW/DVD drive adapter assembly down toward the
chassis until the screws loosened in step 7 can slide through the larger
openings in the keyhole slots.
9.
Place the CDRW/DVD drive adapter assembly in an ESD container. If
requested return the drive to Tekelec using the procedures described in
Appendix B, "Hardware Repair and Return."
10.
Place the disk mounting bracket with the large sections of the keyholes slots
over the # 6-32 screws in the cover standoffs. (These screws were loosened in
step 7.)
11.
Slide the disk mounting bracket up until standoff screws are in the small
sections of the keyhole slots.
12.
Tighten the # 6-32 pan-head screws into the standoffs to secure the drive
mounting bracket.
13.
Attach the data and power cables on the back of the removable media disk
drives. See Figure 7-18.
NOTE: The location of the top cable was marked in step 6 on page 7-35.
7-36
Keyhole Slots
CDRW/DVDs and
Power
Mounting Adapter
Connectors
IDE Connectors
910-0095-001 Revision J November 2007