Figure 7-5. Right Slide Assembly Mounting And Retention Bracket - Tekelec T1000 Hardware Manual

How to Access T1000 AS FRUs
4.
Lift the T1000 AS chassis and carefully insert the inner slide members into the
middle slide members in the frame. See Figure 7-5.

Figure 7-5. Right Slide Assembly Mounting and Retention Bracket

F r o n t
Inner slide member
5.
Push the T1000 AS chassis toward the frame. When the buttons encounter the
middle slide members, simultaneously press the release buttons on the inner
slide members on both the left and right sides.
NOTE: The inner slide members will continue to travel until the release
buttons pop into the round holes of the middle slide members.
6.
At the rear of the frame, do one of the following:
• For Rear Cable Management Arm Systems, attach the cable management
arm to the chassis using the captive knurled fasteners. See Figure 7-6 for
location of the cable management screw holes on the rear of the chassis.
• For Side Cable Management Arm Systems attach the side cable
management arms to the rear of the frame above the rails using the bolts
provided (see Figure 5-9 on page 5-12).
7-16
Retention
bracket screws
Chassis retention
bracket
910-0095-001 Revision J November 2007
Rear frame
adapter bracket
Front slide
assembly bracket
Front frame
adapter bracket
Release button hole
Middle slide member
Slide bearings
03_ts_front_bracketdetail