7.
Attach inner slide members on both sides of the replacement T1000 AS chassis
with four # 10-32 Phillips screws each. Orient the inner slide members with
the roller bearings outward and the center tabs toward the front of the T1000
AS chassis. See Figure 7-23.
8.
If the hard disk drives and/or PCI cards from the failed T1000 AS chassis need
to be moved to the replacement chassis, perform either or both of the
following procedures:
• Procedure 7-10, "Replace a Hard Disk Drive Assembly," on page 7-24
• Procedure 7-12, "Replace a PCI Card," on page 7-37
9.
If requested, return the failed T1000 AS chassis to Tekelec. Arrange the return
shipment by using the procedures in Appendix B, "Hardware Repair and
Return."
10.
This procedure is complete.
Next, perform Procedure 7-7, "Return a T1000 AS Chassis to the Frame," on page
7-15.
910-0095-001 Revision J November 2007
How to Replace T1000 AS FRUs
7-45