Figure 7-10. T1000 As Front Top Cover - Tekelec T1000 Hardware Manual

How to Replace T1000 AS FRUs

Figure 7-10. T1000 AS Front Top Cover

Chassis Retention
Brackets (Remove these Screws)
6.
Grasp the handles on the front top cover of the chassis and lift up until the
constant torque hinges support the weight of the cover and the four attached
disk drives located under the cover.
7.
Do one of the following:
• If this procedure is being performed to replace a failed hard disk drive,
skip to the next step.
• If this procedure is being performed to move hard disk drive assemblies
from a failed T1000 AS chassis to the replacement T1000 AS chassis, note
the position of the hard disk drive assembly that is about to be removed.
The brackets on which the hard disk drives are mounted have position
location labels. From the front of the chassis, the "A" drive is on the left
and the "C" drive is on the right. It is recommended that this entire
procedure be performed to remove the "A" hard disk drive assembly from
the failed T1000 AS chassis and replace it into the "A" position in the
replacement chassis, and then the procedure be repeated to remove the
"C" hard disk drive assembly from the failed chassis and replace it into
the "C" position of the replacement chassis.
7-26
Handles
Captive Cover Screws
(Do NOT Remove
These Screws)
910-0095-001 Revision J November 2007