Table of Contents
Advertisement
How to Locate T1000 AS Part Numbers
NOTE: When the chassis stops moving, the front of the T1000 AS should
be slightly recessed to allow clearance of the handles behind the frame door
when closed.
9.
Adjust the chassis retention brackets on the front of the T1000 AS chassis to
contact the frame adapter brackets when the chassis is positioned correctly in
the frame.
10.
Secure the chassis with one # 12-24 screw in the chassis retention brackets on
each side.
11.
This procedure is complete.
Hard Disk Drive Assembly Part Number Information
The part number information for hard disk drive assemblies is located on both of
the following labels:
• Label on the hard disk drive assembly (see Figure 7-15 on page 7-31).
Use this label during replacement of the part to verify that the correct part
number was ordered (see Procedure 7-10, "Replace a Hard Disk Drive
Assembly," on page 7-24).
• The Base Unit/Hard Disk Drive Label on the outside of the T1000 AS
chassis. Figure B-7 shows where this label is located and Figure B-8 shows
a closeup view of a blank label. Use this label when requesting an RMA.
Procedure B-4 on page B-11 provides instructions about how to access
view this label.
Figure B-7. T1000 AS Chassis Label Locations
Base unit/hard disk
Server
identification
label
B-10
PCI slots label
label
C R IT IC
A L
M IN O R
Caution: Follow shut down
procedure before opening lid
T e k s e r
v e r
P O W E
R B
910-0095-001 Revision J November 2007
Memory label
Advertisement
Table of Contents
