Figure 4-2. Anchor Assembly For Slab Floors - Tekelec T1000 Hardware Manual

Figure 4-2. Anchor Assembly for Slab Floors

5/8 inch rod
5/8 inch nut
Small steel
washer
Large steel
washer
Metal sleeve
Nylon shoulder
washer
Fiber
washer
Nylon collar
Expansion
sleeve
Cone nut
Procedure 4-4.
1.
Use the HEPA vacuum cleaner to collect the dust while drilling holes. At each
anchor location marked on the concrete floor, drill a hole that is 11/16 inches
(18 mm) in diameter to a depth of 3 inches (7.7 cm). The anchor and frame will
not come together properly if the hole is drilled at an angle other than 90°.
NOTE: If any obstruction is encountered while drilling the hole, fill the
unusable hole with liquid concrete. After allowing sufficient time for the
liquid concrete to set, drill the hole at another spot within the marked area.
Clean out each hole after drilling is completed.
2.
Set a fully assembled anchor into each drilled hole.
910-0095-001 Revision J November 2007
Anchor
Assembly
Exploded View
See Note
Threaded rod
Twist off nut
Torque nut
(red plastic
cover)
plate (option)
Fiber
washer
Nylon
shoulder
washer
Note: When an anchor assembly is used on a raised floor,
the anchor assembly must be disassembled and the correct
length of threaded rod of the proper diameter must be used
for the floor height requirement.
04_anchor
Anchor a HD Frame into a Slab Floor
How to Install a T1000 AS Frame
Anchor
Assembly
Nylon
shoulder
washer
Hold-down
Metal sleeve
Fiber
washer
Nylon collar
Expansion
sleeve
Cone nut
Frame
Isolation pad
Floor
4-7