Table of Contents
Advertisement
4.
Create another chalk line that allows 6 inches between each frame for correct
spacing.
Align the template (isolator pad) again against the front chalk line and
continue the process of aligning, marking, and moving the template (isolator
pad) until the site specific number of frame spaces has been laid out.
5.
This procedure is complete.
Next, do one of the following:
• If you are installing the frame on a slab floor, see Procedure 4-4, "Anchor a HD
Frame into a Slab Floor," on page 4-7.
• If you are installing the frame on a raised floor, see Procedure 4-3, "Create
Cable and Anchor Holes for Raised Floors," on page 4-5.
Additional Preparations for Raised Floors
Use the procedures in this section to prepare floors for anchoring frames on raised
floors. For raised floors, you must create cable and anchor holes in the raised floor
tiles.
Procedure 4-3.
1.
Mark the spots where the cable holes are to be drilled. (The spots where the
anchor holes are to be drilled were marked in Procedure 4-2, "Mark Floor
Layout," on page 4-4.)
2.
Mark the corners of the raised floor tiles to ensure the same tiles will be
returned to the same place when the procedure is complete.
3.
Remove the tiles from the equipment area.
4.
Use a HEPA vacuum cleaner to collect the shavings while drilling. Using a
carbide-toothed hole saw of the appropriate diameter, drill the cable holes
required in the raised floor tiles. For the anchor holes, drill 1 inch (2.54 cm)
diameter holes in the tiles corresponding to the marked anchor locations. Use
a file to remove any sharp edges from the drilled tiles.
5.
Return to the equipment area with the drilled tiles and replace the tiles,
making sure the holes match where the frame anchors will be installed.
6.
You have completed this procedure.
910-0095-001 Revision J November 2007
Create Cable and Anchor Holes for Raised Floors
How to Install a T1000 AS Frame
4-5
Advertisement
Table of Contents
