Table of Contents
Advertisement
How to Install the Rectifier
18.
When the breakers that supply power to the T1000 AS chassis are switched
ON, the unit will execute a power up sequence which includes a power-on
self test (POST). For information about initializing T1000 AS applications,
refer to the applications manual.
19.
Replace any plastic panels and doors that were removed.
20.
This procedure is complete.
Next, perform the procedures described in Chapter 6, "Post Installation
Procedures."
How to Install the Rectifier
For information about how to install the rectifier, refer to the documentation that
was delivered with the rectifier.
How to Cable Components Added to Existing Frames
To cable equipment added to an existing frame, follow the directions in one of the
following sections:
• "How to Cable a T1000 AS Unit Added to an Existing Heavy Duty Frame"
on page 5-16
• "How to Cable a T1000 AS and Rectifier Installed in Customer-Provided
Frame" on page 5-17
How to Cable a T1000 AS Unit Added to an Existing Heavy
Duty Frame
WARNING: Verify that all breakers are set to the OFF (O) position.
In a Direct Current (DC) environment, after an additional T1000 AS unit has been
installed, attach cables.
To determine the cables used and how to connect them, refer to the
interconnect
and a diagram of how to connect it.
NOTE: Some of the listed cables are used only as required. Actual cables
used may vary by application.
To view a drawing of a cable, refer to the
the cables that appear in the system interconnect diagram with a link from each
part number to the drawing for that part number.
5-16
diagram, which lists each cable, its quantity, length, how it is used,
DC Cable List
document, which lists all
910-0095-001 Revision J November 2007
DC system
Advertisement
Table of Contents
