Figure 7-16. Hard Disk Drives - Tekelec T1000 Hardware Manual

How to Replace T1000 AS FRUs
14.
Place the hard disk drive and mounting bracket with the large sections of the
keyholes slots over the # 4-32 pan-head screws in the cover standoffs. See
Figure 7-12 for screw locations.
15.
Slide the disk mounting bracket up until standoff screws are in the small
sections of the keyhole slots.
16.
Tighten the # 6-32 pan-head screws into the standoffs to secure the drive
mounting bracket.
17.
Attach the data and power cables on the back of the hard disk drive. See
Figure 7-16 on page 7-32.

Figure 7-16. Hard Disk Drives

Warning label
Hard disk
“A” or “C”
label
Part number
label
Jumper Pins Settings
(Underside of drive)
18.
Do one of the following:
• If this procedure is being performed to replace a failed hard disk drive,
skip to the next step.
• If this procedure is being performed to move hard disk drive assemblies
from a failed T1000 AS chassis to the replacement T1000 AS chassis, repeat
step 7 through step 17 to move the other drive.
19.
Close the chassis top cover.
7-32
Serial number
label
Hard disk drives
Jumper Pins
Data and Power
Cable Connections
Part number
label
Front Top Cover
(shown open)
Removable
"A" Drive
Media Disk Drives
label
position label
910-0095-001 Revision J November 2007
"C" Drive
position label
Serial number
label