Figure 7-23. Left Slide Member Mounting - Tekelec T1000 Hardware Manual

How to Replace T1000 AS FRUs
WARNING: This procedure CANNOT be performed while the T1000 AS
chassis is powered on. Never power OFF a T1000 AS chassis until the
application software and platform operating system (OS) are shut down. If
possible, use the procedures in the application manual for a "soft
shutdown." If the application interface is not operating or is not accessible,
a hard shutdown (turning OFF the breakers) is sometimes required. Contact
Tekelec Customer Care Center before doing a hard shutdown.
5.
Remove the failed T1000 AS chassis from the frame using Procedure 7-6,
"Remove a T1000 AS Chassis from Frame," on page 7-10.
6.
Using a Phillips screwdriver remove, the four # 10-32 screws that attach each
inner slide member to the chassis and set the slide members aside.
NOTE: Observe the orientation of the inner slide members with the roller
bearings outward and the center tabs toward the front of the chassis. The
inner slide members are attached to the replacement T1000 AS chassis in
step 7.

Figure 7-23. Left Slide Member Mounting

7-44
Release
Button
Four #10-32
Phillips Screws
Inner Slide Member
Chassis
Roller Bearings
Chassis Retention
Bracket
910-0095-001 Revision J November 2007
Center Tab