Figure 7-13. Hard Disk Drive Jumper Pins And Settings - Tekelec T1000 Hardware Manual

How to Replace T1000 AS FRUs

Figure 7-13. Hard Disk Drive Jumper Pins and Settings

Warning label
Hard disk
“A” or “C”
label
Part number
label
Jumper Pins Settings
(Underside of drive)
• If this procedure is being performed to move hard disk drive assemblies
from a failed T1000 AS chassis to the replacement T1000 AS chassis, locate
the part numbers on each of the hard disk drive assemblies (see Figure
7-13).
Ensure that the part numbers on hard disk drive assemblies to be moved
match the part numbers for both the A and C positions on the base
unit/hard disk label on the front of the left side of the replacement T1000
AS chassis (see Figure 7-14 and Figure 7-15). If the part numbers do not
match, contact Tekelec Customer Care Center.
7-30
Serial number
label
Hard disk drives
Jumper Pins
Data and Power
Cable Connections
Part number
label
Front Top Cover
(shown open)
Removable
"A" Drive
Media Disk Drives
label
position label
910-0095-001 Revision J November 2007
"C" Drive
position label
Serial number
label