Figure B-9. T1000 As Chassis Front View - Tekelec T1000 Hardware Manual

How to Locate T1000 AS Part Numbers

Figure B-9. T1000 AS Chassis Front View

Chassis Retention
Brackets (Remove these Screws)
5.
From the front of the frame, using the handles on the front top cover of the
chassis, pull forward until the release buttons on the inner arms of the slide
assemblies pop into the holes on each side.
DANGER: If the T1000 AS chassis is pulled too far out after the release
buttons are disengaged, the inner slide members (attached to the chassis)
could come out of the middle slide members (attached to the frame).
6.
Report the requested part number information on the base unit/hard disk
label.
7.
From the front of the frame, simultaneously press the round release buttons
and slowly push the chassis into the frame while observing the cables to avoid
binding or stretching.
NOTE: When the chassis stops moving, the front of the T1000 AS should
be slightly recessed to allow clearance of the handles behind the frame door
when closed.
B-12
Handles
Captive Cover Screws
(Do NOT Remove
These Screws)
910-0095-001 Revision J November 2007