Figure 5-2. Slide Assembly Extended View - Tekelec T1000 Hardware Manual

How to Install an Individual T1000 AS Unit
NOTE: Each T1000 AS chassis is 4 U (7 inches) in height and can be
mounted immediately above or below existing components (zero
clearance). Limits to positioning the T1000 AS in a frame are data cable
lengths, lengths of power cables to the breakers, and location of
interconnected components.
3.
Locate the slide assemblies, which consist of three sections that will be
attached to the T1000 AS chassis and frame (see Figure 5-2).
4.
Separate the inner slide members (with attached rollers) from the other
sections by pulling the inner and outer members apart. When a slide assembly
is approximately halfway extended, a large circular release button, located on
the side of the inner slide member, will pop into a hole in the middle slide
member. Press the release button and continue pulling the slide members
apart until the inner slide member is completely separated. See Figure 5-2 and
Figure 5-3 for details.
NOTE: Only the inner slide member will separate completely; the middle
and outer slide members are permanently connected.

Figure 5-2. Slide Assembly Extended View

Detent Latch
5-6
Middle Slide Member
Outer Slide Member
910-0095-001 Revision J November 2007
Inner Slide Member
Release Button
Located on other side